Pneumatic control technology is made by the air compressor, which is a powerful pressure, so it has a high pressure and power. In a sealed use of glue attention technology, stainless steel is mainly used for constraint and glue dispensing valve, pneumatic control technology has become one of the key points in the rubber industry which is lack of technology.
Price gap between electric and pneumatic
The application point glue of sealing in sensor, glue is used for stainless steel point glue valve accessories, so how to make the point glue valve and double acting can realize the suction, and pneumatic control technology, of course, some people want to know why not use electric products, but also have electric point glue valve, pneumatic point glue valve is no more than twice or three times of the price, or even higher, the rate of return is not cost-effective in industry, only using pneumatic control Only by using this technology can the pneumatic regulating valve be compared with the electric regulating valve.
a - y6调剂控制器
A - y6 regulating controller
Distribution valve to achieve suction, reaction and air pressure
The stainless steel dispensing valve and double acting can realize the suction, which has a direct relationship with the air spring. The air spring can realize the pressure of expansion and contraction according to the range, and the moderate pressure directly invades and changes the spring scale, so that we can make the stainless steel stick back to the suction valve and double acting. At this time, the air pressure control device of each Thai sealant machine can prevent the bad sealing, and can also recycle and double acting. Two gains.
Type of pneumatic control device
Following an inexhaustible improvement of dispensing machine production technology and pneumatic control technology, the lonely pressure control equipment production Xintai, like a 982 dispensing control device, the control device of 983 and 800 years, device 916 creep restraint, etc., the basic industrial production is used for restraint equipment, pneumatic control technology is a mature technology, and the sealed environment is gradually reduced.
Daily maintenance to ensure the normal operation of the equipment
Only in the use of sealing dispenser according to the use of table imitating operation, daily maintenance and test of stainless steel valve sealing, test of gas spring scalability, etc., there will be no problems in the production base, the air pressure control technology is relatively mature, and rarely the distribution caused by air pressure can not be submitted.
If you want to know more about the two-component dispenser, you can follow our website or contact us directly. We will provide you with the most intimate service.